Most Engineering project start with technical drawing and diagrams from which parts are then machined to precise measurements. Reverse engineering 'reverses' this process, dimensions and measurements are obtained from an existing part or even damaged parts, an analysis of its mechanical and physical properties is completed to create a drawing from which the part can be reproduced and remade.
We carry out this process in house, we are then able to make these parts with the tools and machines in the workshop from stock materials. This allows for a full integrated cycle of repair from broken part to reproduced remanufactured part to get you back into operation.
Machines in the workshop used for reverse engineering.
60 inch's between centers
16 inch swing over cross slide
Super precison tool room lathe
18" between centers
6' swing over cross slide
1250x 250 table
400 z axis travel
Heavy duty universal milling machine
1250 x 300 table
400 z axis travel
fully overhauled, reground and new tucite
18" x 6" table
275 mm vertical travel
Reground, re scraped and Restored
Gallery